Installation
Ensure that the unit is installed in the correct position, with the bleed port uppermost as shown in the installation drawings (below). all fittings intended to seat at the bottom of the hydraulic ports must have an included angle of 90°.
Note
When large diameter splines are used please check clearance of the spline in the slave cylinder body. Larger splines also have an increased driven plates hub boss. Please check the clearance of the driven plates at maximum slave travel. See the clutch installation drawing for details.
Mineral oil versions of all the assemblies on this drawing are available, for further information see CP8084-1CD for mineral oil compatible assemblies in the Documents Download Tab.
CP6859 supercedes CP3859 Cylinder series BUT IS NOT IDENTICAL. The differences between CP3859 & CP6859 can be identified by viewing this document: CP3859 - CP6859 Differences.